Long Bore Extendable Drilling System For The Lathe

The Long Bore Extendable Drilling System is ideal solution for boring a starting hole in your hollowing form work piece. This system is consist of three steel rods. The 3/4" diameter steel rods are extremely rigid which perform much better than standard, smaller diameter single rods when drilling on a lathe. Another distinct advantage is that there is no need for a drill chuck or morse taper adaptor. This system is easily mounted to the tailstock on your lathe which will allow you to use the lathe to drill a starter hole on your project. This system as packaged gives you a total reach of 9".
1 ea. Morse Taper #2 Base

1 ea. 3" Extension Rod

1 ea. 3/8" Forstner Bit Holder

Also available are 3" and 6" Extensions.

(MLD1) Long Bore Extendable Drilling System

(MLD2) 3" Extension for Long Bore Extendable Drilling System

(MLD3) 6" Extension for Long Bore Extendable Drilling System